Change Language :

Assembly instructions for twisterband

twisterband


Twisterband cable with A marking and orange measuring line.

TPE outer jacket

Design: Cable selection

When selecting cables, pay attention to particularly good abrasion and sliding properties. The ideal jacket material is TPE.
Recommendation:

chainflex® cable CF9
Cable comparison with an orange exclamation mark showing different cable constructions.

Special shielded cables for use in the twisterband are in preparation. Please contact us if the use of shielded cables is necessary.

Design: filling

twisterband version with clasp:TB20.44.18.x.01.0 | TB30.75.22.x.01.0

Twisterband assembly drawing with dimensions and sections A to E.

A = Separate cable with separators

B = insert cable sorted by diameter or bend radius. Insert thinner, smaller ones inwards and larger ones outwards.

C = No more than two cables on top of each other. 10% of the larger diameter or min. 1 mm

D = Between all cables
10% of the larger diameter or min. 1 mm

E = Between cable and separators
10% of the larger diameteror min. 1 mm

twisterband version with Easy fastener:TB12.23.09.x.01.0 | TB20.44.12.x.01.0

Mounting drawing with three variants of minimum clearances for a cable bundle in the Twisterband.

A = Insert cable sorted by diameter or bend radius. Insert thinner, smaller ones towards the inside and larger ones towards the outside.

B = Between all cables min. 1 mm or 10% of the larger diameter => Ø B

C = No more than 2 cables on top of each other.
min. 1 mm or 10% of the larger diameter

Mounting: mounting bracket

Twisterband assembly with an arrow pointing to the guide groove of the part.

1. Push the twisterband between the steel parts.

Twisterband mount with screw and perforated plates.

2. fix the twisterband to the connecting element by screwing it in place.

Assembly: Guide shaft

Twisterband cable guide around an orange axle.

In vertical installation position from 1500° angle of rotation, use a centred shaft as guidance.

igus Twisterband energy chain in curved and straight form.

In horizontal installation position, always use a centric shaft as support.

Mounting: strain relief

Twisterband installation showing incorrect and correct hose routing, marked with X and tick.

- Relieve the strain on the cables at both ends
- Make sure that the knot of the cable tie does not point in the direction of the energy chain

End position:

Twisterband with a minimum bend angle of 90 degrees and an incorrect example marked with an X.

The twisterband must not be rotated to the end. In order not to put too much strain on the cable, a reserve of at least 90° must be planned before each attachment point.

twisterband®

Assembly videos

Contact us

Contact details

justin leonard
Justin Leonard01604 677240Contact us

Opening hours

Office hours

Monday to Friday from 8 am - 8 pm.

Live chat:
24h