The best material combination for drylin linear guides

The material iglidur® J achieved the best results in our tests on almost all shaft materials. Comparative laboratory tests show that iglidur® J is the polymer with the lowest friction and wear for linear applications.

Special specification of iglidur® J:

• maintenance-free dry operation
• low coefficient of friction with all materials
• excellent wear resistance
• Very low moisture absorption
• Great all rounder material
• 
  

iglidur® J200 was specially developed for linear applications in combination with hard-anodised aluminium surfaces. This combination achieved by far the best results in our laboratory tests.

Special specification of iglidur® J200:

• absolutely maintenance-free
• extreme service life on hard-anodised aluminium
• low coefficient of friction with anodised aluminium
• Excellent wear resistance with anodised aluminium

iglidur® X is characterised by its high temperature resistance and compressive strength, combined with extreme chemical resistance. iglidur® X achieves its best wear resistance on stainless steel and chrome-plated steel shafts.

Special specification of

iglidur® X:

• absolutely maintenance-free
• Temperature resistance -100°C to +250°C in continuous operation
• Universal chemical resistance
• Very low moisture absorption

iglidur® E7 is the specialist for steel and stainless steel shafts. This material is very vibration-damping and particularly abrasion-resistant and achieves an 8 times higher service life.

Special specification of iglidur® E7:

• Quiet running due to good damping properties
• Extremely low coefficient of friction
• self-lubricating due to incorporated solid lubricants
• corrosion-free
• Very low moisture absorption